A browser-based virtual ECU environment where you can run real UDS diagnostics, analyze CAN traffic, inject faults, and practice flash sequences - all against persistent, stateful ECU instances. No hardware required.
Professional-grade tools without the $50K hardware investment
Send raw UDS requests, view parsed responses, manage sessions, perform security access, read/clear DTCs, and read DIDs - all in real-time.
Launch Console →Live CAN frame viewer with filtering, DBC-based signal decoding, message cycle time monitoring, bus load calculation, and trace export.
Launch Monitor →Trigger sensor disconnects, communication loss, voltage anomalies, and more. Watch how DEM, FIM, and the diagnostic layer respond in real-time.
Launch Fault Injection →Practice complete reflash sequences: pre-conditions check, security unlock, erase memory, transfer data blocks, checksum verification, ECU reset.
Launch Flash Sim →Explore stored DTCs with full status byte visualization, freeze frame snapshots, extended data records, and diagnostic analysis notes per fault.
Launch DTC Manager →Browse all Data Identifiers with categories, hex/ASCII views, UDS command preview, and write capability - across all three ECU types.
Launch DID Browser →Each ECU model covers different skill levels and protocol stacks
Your starting point. A classic gateway controller with CAN routing, network management, and standard UDS diagnostics.
Complex engine management unit with CAN-FD, advanced DTCs with freeze frames, MIL logic, and calibration parameters.
Next-gen domain controller running Adaptive AUTOSAR concepts - Ethernet-based diagnostics via DoIP and SOME/IP service discovery.
20 interactive simulations covering AUTOSAR BSW modules, communication protocols, diagnostics, and SDV architecture
Task scheduling, alarms, counters, ISR categories, resource management, and timing visualization.
Engineer+I-PDU routing, signal gateway, I-PDU groups, TP segmentation, and end-to-end data flow tracing.
Engineer+Runtime Environment port connections, runnable-to-task mapping, and inter-ECU communication paths.
Engineer+Mode rules, actions, arbitration, ECU state management, and BSW module orchestration.
Engineer+Diagnostic Event Manager - trigger faults, watch debouncing, DTC status bytes, and event memory.
Engineer+AUTOSAR NM state machine - Bus Sleep, Normal, Ready Sleep, Repeat Message with configurable timers.
Engineer+End-to-End data protection profiles with CRC, sequence counter, timeout, and state machine.
Engineer+NvM block management, Fee wear leveling, immediate/deferred writes, and multi-layer request queue.
ProSecure Onboard Communication - MAC generation, freshness management, and authentication profiles.
ProDecode CAN frames, apply DBC files, filter by ID, measure cycle times, and calculate bus load.
Engineer+Master/slave scheduling, signal encoding/decoding, and LIN diagnostics for body electronics.
Engineer+Diagnostics over IP - vehicle discovery, routing activation, and diagnostic tunneling over TCP/IP.
ProService discovery, pub/sub events, method invocation, and Adaptive AUTOSAR communication.
ProInteractive ISO 14229 service map, visual request/response builder, and NRC decoder.
Starter+Read PIDs, DTCs, emissions readiness, freeze frame data, and compare OBD vs UDS diagnostics.
Starter+DAQ list configuration, parameter editing, characteristic curves, and A2L file exploration.
Engineer+Complete ECU reflash - security unlock, memory erase, data transfer, and CRC verification.
Engineer+Advanced diagnostic scripting - automated sequences, flash programming workflows, and test reports.
Proara::com service discovery, ara::exec execution management, and manifest configuration.
ProSoftware-Defined Vehicle - service mesh, OTA updates, container orchestration, and SOME/IP routing.
ProSee all plans and pricing on our dedicated pricing page.
Join 15,000+ automotive engineers learning on Motodemy. No hardware required.
Start Free Trial